Safety instructions
Manual piCOMPACT
®
23 SMART IO-Link Ready 2 channel Page 7/24
2.3 Intended use
•
For professional use only.
•
The product is used for creating vacuum or
blow.
•
The product shall be used to evacuate air (non-
liquids) from a volume to create vacuum for
gripping, holding and processes.
•
The product can be used to blow air for surface
cleaning and to remove vacuum from a volume.
•
The product can be used to detect and monitor
vacuum.
•
The product shall be used in environments
within the product’s specifications and
certifications.
•
The product shall be installed in accordance to
installation instructions.
•
The product shall be maintained in accordance
to maintenance instructions.
•
Troubleshooting shall be conducted in
accordance to manual instructions.
2.4 Misuse
•
Do not use the product if it is damaged.
•
The product shall not be used to create vacuum
or blow for other purposes than the intended
use.
•
The product shall not be used to evacuate solid
content without the use of filter.
•
Do not use the product to evacuate hazardous
substances and/or gases without proper
treatment of exhaust flow.
•
Do not use the equipment as a stand-alone unit
to fulfill international lifting standards.
•
Do not use the product for evacuating liquids.
•
Do not use the product if the exhaust is
restricted or blocked.
•
Do not use the product if the compressed air
line is not properly secured.
•
Do not use the product if vacuum and exhaust
port are simultaneously blocked when unit is
generating vacuum.
•
Do not keep the valves open when the product
is not in operation for a prolonged time. The
seals and lubrication will degrade.
•
Do not install the product in a fully closed
compartment, without ventilation and exhaust
channeling.
•
Do not use blow-off functions or ejector
exhaust for pressurizing components such as
cylinders and/or tank-volumes.
•
Do not use compressed air pressure or electrical
voltage outside the specification.
To Next Page
Loading...