Pico Macom SIRD-FTA - 3 Receiver Connections; Connecting to Antenna and Dish

To Next Page

To Previous Page

3.1 Connecting to Antenna and Dish

This Receiver works only with a satellite dish that can access free-to-air pro-

gramming. The diagram below shows the basic connections required for the

satellite LNB, TV and other possible connections on the rear panel. (Consult

the following pages for additional connections.) lf you need assistance to iden-

tify your specific equipment configuration, contact your authorized dealer.

Instructions:

1. Connect satellite input cable to Receiver “IF In.”

2. Connect cable from Receiver’s “Out to TV” to TV’s “In from Antenna.”

3. Connect outdoor antenna cable to Receiver’s “Antenna In.”

For safety reasons, keep equipment unplugged from power sources until all

cables are properly connected.

3.1 Connecting to Antenna and Dish

RECEIVER CONNECTIONS