Pico Macom SIRD-FTA - Installation Settings

To Next Page

To Previous Page

4.3 Installation Settings

Select <Installation> in <Main Menu> by using CH+/–, press OK, you will see

the sub-menu as shown in the following figure. It has four items: Satellite

Search, Transponder Search, Satellite Setting and Transponder Setting.

Satellite Search

Select <Satellite Search> by using CH+/–. Press OK to view the sub-menu as

shown in the following figure.

A. Sat name

Select <Sat name>, then press VOL+. Select satellite by using CH+/– or

PGUP/PGDW. Press OK to confirm it.

B. Transponder

Select a valid transponder in the satellite to check the signal. Select

<Transponder>, then press

VOL+. Select transponder by using CH+/– or

PGUP/PGDW. Press OK to confirm it.

C. LNB frequency

You can select the predefined LNB frequency by using VOL+/– . Manually

enter a specific frequency in MHz unit by pressing

numeric keys.

4.3 Installation Settings

MAIN MENU