13
Pressing the Loop 2 footswitch while Loop 1 is recording will close Loop 1 and begin recording on
Loop 2.
In parallel mode, Loop 1 will immediately begin playback when Loop 2 starts recording.
In series mode, Loop 1 will simply close and be ready for playback the next time you hit the Loop 1
footswitch.
When a loop has been recorded but is stopped, pressing that loop’s footswitch will restart playback.
The corresponding LED will glow green to indicate playback.
The Play function is tied to the ARM / ALL setting.
Pressing stop will stop audio playback.
The Stop function is tied to the ARM / ALL setting.
Double pressing the Stop footswitch within 1 second will override the ARM / ALL and CUE / FADE
settings and will stop all loop audio.
To erase a loop, press and hold down the Stop footswitch.
If a loop is stopped and armed, pressing the Undo remote switch will erase that loop.
When the erase command is triggered, the Stop LED, the current Arm LED, and the Multi-Segment
Digit will flash once to indicate audio has just been erased.
The Erase function is tied to the ARM / ALL settings.
Jump Record
Play
Stop
Erase
To Next Page
Loading...
