pigtronix INFINITY 3 - Infinity 3 Rules: Sync, Series, and Overdub; Sync;Multi, Series Loops, and Cue;Fade; Overdub Functionality

14
Overdub lets you add additional material to the original loop.
Pressing the Loop footswitch when a loop is playing back will start overdubbing. The corresponding
footswitch LED will glow orange to indicate Overdub.
Pressing the loop footswitch during an overdub will close that overdub.
Aer closing an overdub you can choose to reopen it by pressing the loop footswitch, any time
before the end of the current loop cycle. At the end of the loop cycle, all audio recorded during that
cycle is merged and saved as a single overdub.
Pressing Stop in the middle of an overdub will cancel that overdub and eliminate the dubbed audio.
When Sync/Multi is turned off, the lengths of Loop 1 and 2 are unrelated and playback is unsynchronized.
If Loop 2 is recorded when Sync/Multi is off, it cannot be turned off until Loop 2 is erased.
When Sync/Multi is turned on, the multiplier value determines the length of Loop 2 relative to Loop
1. At x1 (Sync) the lengths of Loop 1 and Loop 2 are identical, and they begin and end at the same
points. Upon holding Sync/Multi and selecting any value greater than 1 using the Preset rotary knob,
Loop 2 is that many times longer than Loop 1.
When Multi is on and the Loop 2 footswitch has been pressed, recording on Loop 2 will automatically
begin at the start of the next Loop 1 cycle, and close aer the selected number of cycles.
When Series is on, only one of the two loops can be played back at any given time.
When Series is on, enabling playback or recording on a loop will immediately stop playback of the
previously selected loop, closing any overdub that was in progress.
In Series mode, when recording on Loop 1, pressing the Loop 2 footswitch will close Loop 1, and will
simultaneously arm and begin recording on Loop 2. Pressing the Loop 1 footswitch next will cause
Loop 2 to close and will simultaneously arm and begin playback on Loop 1.
In Series mode, when Cue is selected, switching between loops at any time will cue the selected loop
to begin playback automatically at the end of the current loop cycle.
Similarly, when Fade is selected, switching between loops at any time will cue the selected loop to
begin playback automatically at the end of the current loop cycle.
Overdub
Sync/Multi
Series Loops
Series Cue and Fade