21
Hold down SAMPLE RATE to toggle the click killer on and off.
The loop boundary Click Killer is a super quick crossfade between the beginning and end of a loop.
For musicians who want to construct sustained droning loops with overdubs that cross the loop
boundary, turning the Click Killer off will result in seamless loops. For more rhythmic and song-
based performances, we recommend leaving the Click Killer on.
Undo is triggered by shorting the tip to the sleeve of the undo jack. To undo overdubs, a 1, 2, or 3
button momentary remote switch is required. This should be connected to the Undo jack using a TRS
(balanced 1/4”) cable.
When an overdub is playing back (Loop LED is green), pressing the Undo switch will remove that
overdub instantly, and the overdub is retained for Redo if desired.
You can only undo your most recent overdub; once you open and then close a new overdub, the
previous overdub layer will be merged with the base layer at the end of the current loop cycle and
can no longer be undone.
When an overdub is being recorded (Loop LED is orange), pressing the Undo switch will cause the
Infinity to permanently erase that overdub at the end of the current loop cycle. Any material from
previous overdubs that have already been merged with the initial recording will not be undone.
We recommend that you use the Pigtronix Universal Remote switch with the Infinity 3.
Plug your remote switch into the Undo jack using a ¼” TRS cable.
Hold the ARM / ALL + STEREO / SPLIT during boot to reformat the microSD Card. Once the unit
boots up, the display will show “r” while the card is reformatted and then it will show a digit. Use the
rotary encoder to select how many presets you would like and then press down on the encoder to
finish the reformat process.
CAUTION: This action will erase all saved presets and recorded loop audio!
See the MIDI section below for information on the MIDI boot options.
Click Killer
Undo
Reformat SD Card
MIDI Boot Options
REMOTE SWITCH FUNCTIONS
To Next Page
Loading...
