20
Hold Loop 1 during boot to toggle Auto Zero Record.
With Auto Zero Record off (Loop 1 LED is off during boot), the MIDI downbeat is reset on the first
received note or MIDI start.
With Auto Zero Record on (Loop 1 LED is lit red during boot), the MIDI counter is reset on the initial
record of Loop 1.
This effectively lets you establish the downbeat while still obeying an external MIDI clock source. This
is very helpful in live looping situations.
Hold Loop 2 during boot to toggle Mono Mixdown.
With Mono Mixdown off (Loop 2 LED is off during boot), the Infinity 3 outputs in stereo (Default).
With Mono Mixdown on (Loop 2 LED is lit red during boot), both input channels run into a single
output. Both Outputs 1 and 2 will receive the mono mix of all recorded material.
Mono Mixdown does not apply to pass through audio.
Hold Stop during boot to toggle Stutter.
Stutter replaces the functionality of the Reverse button on the Remote Switch.
With Stutter off (Stop LED is off during boot), the Reverse button on the Remote Switch functions
as expected.
With Stutter on (Stop LED is on during boot), pressing the Reverse button on the Remote Switch
causes the armed loop to be played from its start point immediately.
Hold SYNC / MULTI to turn on Overdub syncs to Loop Boundary.
Overdubs will open and close automatically at the loop boundary when triggered in advance.
Auto Zero Record
Mono Mixdown
Stutter
Overdub Syncs to Loop Boundary
To Next Page
Loading...
