PIKO 55016 - Features

System
light

PIKO SmartControl
light
is a digital control system for both aspiring model railway beginners and
experts. It consists of the hand controller PIKO SmartController
light
and the digital central station
PIKO SmartBox
light
, which are connected via the enclosed spiral cable.
With PIKO SmartControl
light
you can control DCC locomotives, switch magnetic accessories
HJWXUQRXWVDQGDFWLYDWHURXWHV,WPDVWHUVHYHU\WKLQJWKHPRGHOUDLOZD\HQWKXVLDVWQHHGVIRU
enjoyable operation of a modest-sized digital model railway.
The PIKO SmartController
light
is the intelligent hand controller for the PIKO SmartControl
light
system.
By using a PIKO #55044 Loco-Net converter it can also be used as an additional corded hand
FRQWUROOHUIRUWKH3,.26PDUW&RQWUROV\VWHPRURWKHUGLJLWDOFHQWUDOVWDWLRQVZLWK/RFR1HW
®
.
Features
• With the digital central station, you can individually and simultaneously control up to 20
locomotives.
 7KHGLJLWDOFHQWUDOVWDWLRQVXSSRUWVWKH'&&GDWDIRUPDWZLWKDQGVSHHGVWHSV
• You can individually set the data format for 9,999 locomotive addresses.
• You can control up to 24 special functions for each locomotive address.
 :LWKWKHGLJLWDOFHQWUDOVWDWLRQ\RXFDQFRQWUROXSWRPDJQHWLFDFFHVVRULHVZLWK'&&
data format, for example turnouts and signals.
• The states of the magnetic accessory addresses 1-1,024 are permanently saved, so that they
are displayed correctly after a reboot of the system.
• The PIKO SmartController
light
can memorize up to 16 different routes (each route can
LQFOXGHQXPHURXVVZLWFKLQJVHTXHQFHV
 (YHU\URXWHFDQVZLWFKEHWZHHQWKHPDJQHWLFDFFHVVRU\QRWRLQXSWRVWHSV
• The output of the main track of the digital station supplies a current of 2 A and is protected
against short circuits and overheating. This allows the simultaneous operation of up to 4 trains
GHSHQGLQJRQWKHXVHGVFDOHZLWKRXWKDYLQJWRXVHDQ\DGGLWLRQDOERRVWHUV
• The digital central station is equipped with an extra output for a programming track with a
maximum current of 250 mA. During programming the output of the main track is switched off.
• With the digital central station, you can program DCC decoders as well as programmable
LocoNet
®
devices.
• The station also has a special output for a reverse loop relay.
• The digital central station is equipped with two LocoNet
®
ports at the back.