PIKO 55016 - Display operating status; Technical data; Digital central station specifications; PIKO SmartController light specifications

System
light
26
I. Display operating status
Red LED off - Green LED on Track current switched on
QRUPDORSHUDWLQJVWDWXV
Red LED on - Green LED off Track current switched off
(stop key pressed, short circuit or during active
GHFRGHUSURJUDPPLQJ
5HG/('RQ*UHHQ/('ÀDVKLQJ Overheating
5HG/('ÀDVKLQJ*UHHQ/('RII Undervoltage at the LocoNet
®
T power supply
(Overload on the LocoNet
®
7SRUW
5HG/('RII*UHHQ/('ÀDVKLQJ Digital central station currently in
LocoNet
®
programming mode
II. Technical data
a. Digital central station
• Power supply: Input: 240 V 50 Hz, Output: 15 V= / 2 A
• max. load main track output: 2 A
• max. load programming track output: 250 mA
• max. load LocoNet
®
-T: 500 mA
 'LPHQVLRQV[[PP
b. PIKO SmartController
light
 [PPKLJKGH¿QLWLRQGLVSOD\IRUDGHWDLOHGUHSUHVHQWDWLRQRIWH[WDQGV\PEROV
• LocoNet
®
port
• Power consumption during normal LocoNet
®
operation: 25 mA
 'LPHQVLRQV[[PP
III. Safety warnings
• Please read the safety warnings and this instruction manual before using the devices.
• Always treat your PIKO SmartControl
light
devices with care! The devices contain sensitive
electronics; therefore, you should avoid exposing them to harsh impacts, moisture and
extreme temperatures.
• The devices are not toys and should not be handled by children under the age of 14.
• Never insert the connection cables into a power socket!
• Always check the power supply for damage to the cables, the plugs, the case or to other
parts. In case of any damage, discontinue use of the device!