9
Getting started
Supersound 202 is easy to use. To play DAB or FM radio, all you need is a
power source (100-240V mains supply); For internet connected modes such as
Internet radio, you also need a broadband Internet connection.
Setup Wizard
When Supersound 202 is started for the first time, it runs through a setup wizard
to configure settings for date/time and network. Once this has finished, the
system is ready to use in most modes.
Note: To change these settings later, select MENU > System settings >.
To run the setup wizard again, select MENU > System settings > Setup wizard.
Select Yes to start the setup wizard.
If you choose No, the next screen asks if you would like to run the wizard next
time Supersound 202 is started. The system then starts without configuring
time/date and network settings and enters the Main Menu.
Note: If power is removed while the wizard is in progress, the wizard will run
again next time Supersound 202 is started.
12/24 hour display
To change between 12 and 24 hour display, select 12/24 hour and select your
preference.
Set Time/Date (wizard)
The date and time are displayed as dd-mm-yyyy and hh:mm with the first value,
dd, active (flashing).
Adjust each value with the SELECT control. As each value is set by pressing the
SELECT control, the next value becomes active ready for adjustment.
To Next Page
Loading...
