Pinnacle Technology OS2CX - Power Connections

9
7. POWER CONNECTIONS
There are 3 methods for OS2X to get power supply.
Method 1: Use the attached communication line to connect Aclas ECR as below picture.
Customer can self-define the length of communication line, if the line is too long,
customer can cut one end of crystal head short and follow the connection mode below to
make a new one.
PHONE4
Pin
Signal name
1
VDD
2
GND
3
TXD
4
RXD
PHONE4
Pin
Signal name
1
VDD
2
GND
3
RXD
4
TXD
Connect to
OS2X
Connect to Aclas ECR
or LP1X label printer
RS232 line
Able to self-define the length
Connection mode