Pioneer CT-900 - User Manual

Operating Instructions
Bedienungsanleitung
Mode d'emploi
Istruziom per l'uso
English; Page 1
Deutsch; Seite 7
Francais; Page 11
Italiano; Pag. 15
STEREO CASSETTE TAPE DECK
STEREO-KASSETTENBANDGERAT
PLATINE CASSETTE STEREO
REGISTRATORE A CASSETTE STEREO
Photograph shows BLACK finished model.
“This product is manufactured to comply with the radio
interference requirements of EEC Directive 76/889/EEC
and 82/499/EEC.”
Thank you for buying this Pioneer product.
Please read these operating instructions thoroughly, so you. will
know how to operate your model properly. After you have finished
reading the instructions, put them away in a safe place for future
reference. For the sake of convenience, these operating instructions
are based on the model HEM, and they can be used for the HB, HP,
KU, KC, D and D/G models.
The differences between the models are given below.
HEM model:
For Europe excluding U.K. (‘HEM’ stamped on packing case):
Power line voltage is AC 220 volts.
HB model:
For U.K. (‘HB’ stamped on packing case): Power line voltage is AC
249 volts.
HP model:
For Australia (‘HP’ stamped on packing case): Power line voltage is
AC 240 volts.
KU and KC models:
For U.S.A. and Canada (’KU’ or ‘KC’ stamped on packing case):
Power line voltage is AC 120 volts.
D and D/G models:
For destinations excluding above (‘D’ or ‘D/G’ stamped on packing
case): A 3-point (120 V/220 V/240 V) voltage selector switch is
provided.
NOTE:
Depending upon the model, the design of the power plug and the
power outlet differs.
The line voltage selector switch is located on the rear panel of
the unit. Please check that it is set properly before plugging the
power cord into an outlet, If it is not set properly, change the
setting of it according to the LINE VOLTAGE SELECTION(D
and D/G meadels only).
IMPORTANT NOTICE (For KU and KC models)
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card and
keep in a secure place. This is for your security.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLI-
ANCE TO RAIN OR MOISTURE.
LINE VOLTAGE SELECTION
(D and D/G models only)
Before your model is shipped from the factory, the switch is set to
the power requirements of the destination; nevertheless, you should
check that it is set properly before plugging the power cord into the
AC outlet.
1. Disconnect the power cord.
2. Provide yourself with a medium size screwdriver.
3. Insert the screwdriver into the groove on the voltage selector and
adjust to the voltage value of your area.
Screwdriver
HEM (for Europe excluding U.K.), HB (for U.K.), HP (for
Australia), KU (for U.S.A.) and KC (for Canada) models are not
provided with a LINE VOLTAGE SELECTOR switch.
dW) PIONEER’
Gres Mant
am)
=<
<
aa
=

Pioneer CT-900 Specifications

General

Brand	Pioneer
Model	CT-900
Category	Tape Deck
Language	English