STEREO
CASSETTE
TAPE
DECK
GT-A9
Thank
you
for buying this
Pioneer
product.
Please
read
these operating instructions
thoroughly, so
you
will
know
how to operate
your
model
properly.
After
you
have
finished reading
the instructions,
put
them away
in,
a safe
place
for future reference.
For the sake of convenience, these operating
instructions are
based
on the model
HEM, and they can be used
for
the HB,
HP, KU, KC, D
and
D/G models.
The differences between the models are
given
below.
HEM model:
For Europe excluding U.K.
('HEM'
stamped on
packing
case):
Power
line voltage is AC 220
volts.
HB model:
For
U.K.
('HB'
stamped on
packing
case):
Power line voltage
is AC
240 volts.
HP model:
For A.rstralia
('HP'
stamped on
packing
case):
Power line voltage
is
AC 221.0 volts.
KU and KC
models:
For U.S.A. and Canada
('KU'
or
'KC'
stamped on
packing
case):
Power line voltage is AC 120
volts.
D and
D/G models:
For destinations excluding above
('D'
or 'DlG' stamped on
packing
case):
A
3-point
(120
V
/220
V
/240
V)
voltage selector
switch
is
pro-
vided.
NOTE:
Depending
upon the model, the
design
of the
power
plug
and the
power
outlet differs.
The
line vottage
selector
switch is located on the
rear
panel
of the
unit. Please
check that
it is set
properly
before
plugging
the
power
cod into an
outlet.
lf it is not set
properly,
change
the setting of
it
according
to the LINE
VoLTAGE SELECTION
on
page
4.
IMPORTANT NOTICE
(For
KU and KG
models)
The
serial number
for
this equipment
is located on the
rear
panel.
Please
write this serial number on
your
enclosed
warranty card
and
keep in
a secure
place.
This
is for
your
security.
WARNING:
TO PREVENT
FIRE OR
SHOCK HAZARD, DO NOT
EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.
(D
rrloNEEFl'
To Next Page
Need help?
General
