To Next Page

To Previous Page

section

(Before

you

start

)

c )

Before

connedingl

installing

the

amplifier

AWARNING

• Handling the cord on this product or cords

as-

sociated with accessories sold with the pro-

duct

will expose

you

to chemicals listed on

proposition

known to the State of California

and other governmental entities to cause can-

cer and birth defect or other reproductive

harm.

Wash

hands after handling.

•

The

use of a special

red

battery and ground

wire

RD-223,

available separately, is recom-

mended. Connect the battery wire directly to

the car battery positive terminal ® and the

ground wire

the car

body.

• This

unit

for vehicles with a

V battery and

negative grounding. Before installing in

re-

creational vehicles, trucks or buses, check the

battery voltage,

• The black cable is ground. When installing

this unit, make sure to connect the ground

wire first. Ensure that the ground wire is prop-

erly connected to metal parts of the car's

body. The ground wire of the one of this unit

must

connected to the car separately with

different screws. If the screw for the ground

wire loosens or falls out, it could result in fire,

generation of smoke or malfunction.

• Use a fuse of the rating prescribed.

• Check the connections of the power supply

and speakers if the fuse of the separately sold

battery wire or the amplifier fuse blows. Deter-

mine and resolve the cause, then replace the

fuse with identical equivalent.

• Always install the amplifier on a flat surface.

not install the amplifier on a surface that

is not flat or on a surface with a protrusion.

Doing so could result in malfunction.

• When installing the amplifier, do not allow

parts such

extra screws to get caught

be-

tween the amplifier and the automobile.

Doing so could cause malfunction.

•

not allow this unit to come into contact

with liquids. Electrical shock could result.

Also, damage to this unit, smoke, and

over-

heating could result from contact with liquids.

The

surfaces of the amplifier and any attached

speakers may also heat up and cause

minor

burns.

•

the event of any abnormality, the power

supply to the amplifier is

cut

off to prevent

equipment malfunction. If this occurs, switch

the system power

OFF

and check the power

supply and speaker connections. If

you

are un-

able to determine

the

cause, please contact

your dealer.

• Disconnect the negative terminal of the bat-

tery before installation.

ACAUTION

• Always keep the volume low enough

hear

outside sounds.

• Extended use of the car stereo while the en-

gine is at rest or idling may exhaust the bat-

tery.

'-'

Important (Serial number)

The serial number is located on the bottom of

this unit.

For

your own security and convenience,

sure to record this

number

on the enclosed

warranty

card.~