How to fix no sound on Pioneer HTP-071 Home Theater System?
If you are getting no sound from your Pioneer Home Theater System, there are a few potential causes: * The speaker wire might be incorrectly connected - ensure it is connected correctly. * The receiver might be off - turn the receiver on. * The volume control might be at zero - slowly turn up the volume.
What to do if Pioneer Home Theater System speakers stop producing sound suddenly?
If your Pioneer Home Theater System speakers suddenly stop producing sound, it may be due to the activation of the automatic protection circuit caused by an excessively large signal input. To fix this, simply turn the volume down to allow the speakers to resume normal output.
Why is my Pioneer HTP-071 Home Theater System sound distorted?
If you're experiencing distorted sound from your Pioneer Home Theater System, it could be due to an extreme signal condition. Try turning down the receiver’s output level by adjusting the volume, bass control, or bass boost to lower the signal level.
Why is there so much noise when listening to AM/FM on my Pioneer Home Theater System?
If you're experiencing a lot of noise when listening to AM or FM broadcasts on your Pioneer Home Theater System, it could be that the AM loop antenna or the FM indoor antenna is too close to the unit. Try increasing the distance between the AM or FM antenna (for indoor use) and the unit.
General| Product color | Black |
|---|---|
| RMS rated power | 600 W |
| Recommended usage | Home theatre |
| Audio output channels | 5.1 channels |
| Amplification device included | Yes |
| Total Harmonic Distortion (THD) | 10 % |
| Amplifier dimensions (W x D x H) | 435 x 168 x 362.5 mm |
| Satellite speaker type | - |
| Satellite speaker weight | 600 g |
| Number of satellite speakers | 2 |
| Satellite speakers RMS power | 100 W |
| Satellite speaker dimensions (WxDxH) | 106 x 116 x 106 mm |
| Center speaker weight | 1000 g |
| Center speaker dimensions (WxDxH) | 270 x 100 x 106 mm |
| Subwoofer weight | 6500 g |
| Subwoofer dimensions (WxDxH) | 230 x 408 x 344 mm |
| Power source | AC |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 165 W |
Weight and Dimensions| Set weight | 7600 g |
|---|
Covers warnings for electrical shock, lightning, and fire hazards from liquid and flames.
Explains the STANDBY/ON switch does not fully cut power and the importance of unplugging the unit.
Overview of connecting speakers as part of the setup process.
Overview of connecting playback components for surround sound.
Steps for powering on the system and making initial regional/environmental settings.
Instructions for selecting sources and basic sound adjustments.
Covers remote buttons for system setup, component control, and navigation.
Instructions for loading batteries and associated safety warnings.
Provides tips on optimal speaker placement for sound quality.
Details how to connect speakers using bare wire and surround back speakers.
Explains HDMI technology, its supported formats, and features like HDCP.
Illustrates HDMI connections for TVs and playback devices, including ARC considerations.
Steps for safely plugging the receiver into a power outlet.
Steps for selecting and playing audio sources using the remote or front panel.
Guide on choosing the correct audio input signal for each source.
Guide to selecting various listening modes based on source and environment.
Details on surround sound modes, including tables of suitable sources and speakers.
Detailed settings for speaker size, number, and crossover network.
Steps to enable and configure the ARC setting in the HDMI Setup menu.
Important notes and procedures before starting ARC operation.
Guidance for diagnosing and resolving common operational problems.
Addresses issues like no picture or sound when using HDMI connections.
Procedure for resetting all receiver settings to their original factory defaults.
Lists detailed specifications for audio, video, tuner, and digital sections, plus included parts.
To Next Page
