Pioneer PD-F25 - Page 11

PD-F25
@ How to install the disc table.
[1] Use Nipper or other tool to cut the two sections marked @ in figure [1].
Then remove the Spacer.
[2] White supporting the Spindle Motor Shaft with the stopper, put Spacer on top of the Yoke M,
and stick the Disc Table on top (takes about 9kg pressure). Take off the Spacer.
ol [2]
Spacer
(Pressure of about 9 kg)
bo Gb Disc Tabie
—
Spacer Setting
Position
Float Base
0.9 mm+0.05 mm 6.9mm
11