Need help?Do you have a question about the Pioneer PL-500X and is the answer not in the manual?
Procedure to remove the turntable cabinet and its top cover.
Steps to disconnect and remove the tonearm assembly from the base.
Guide for fine-tuning the direct-drive motor speed using an oscilloscope.
Details on adjusting tonearm lowering, misoperation, and auto-return functions.
Diagram showing cabinet components and their part numbers.
Diagram showing sub panel components and their part numbers.
Diagram showing direct-drive motor components and their part numbers.
List of components for control, semiconductor, and other PC board assemblies.
Procedure to remove the turntable cabinet and its top cover.
Steps to disconnect and remove the tonearm assembly from the base.
Guide for fine-tuning the direct-drive motor speed using an oscilloscope.
Details on adjusting tonearm lowering, misoperation, and auto-return functions.
Diagram showing cabinet components and their part numbers.
Diagram showing sub panel components and their part numbers.
Diagram showing direct-drive motor components and their part numbers.
List of components for control, semiconductor, and other PC board assemblies.
General| Wow and Flutter | 0.025% (WRMS) |
|---|---|
| Signal to Noise Ratio | 78dB (DIN-B) |
| Effective Arm Length | 221mm |
| Tracking Force Range | 1.5 - 2.5g |
| Power Requirements | AC 120V, 60Hz |
| Platter | Aluminum die-cast |
| Speeds | 33 1/3 and 45 rpm |
| Output Voltage | 3.5 mV |
To Next Page
