Pioneer SA-600 User Manual

Details wide frequency response, low distortion, high S/N ratio, and stability due to silicon transistors.

Input jacks for turntables, tuners, tape decks, microphones, and other sources.

Ability to drive two pairs of speaker systems separately or together via front panel switch.

Allows separate use of pre- and power amp stages for multi-amplifier systems.

Includes click-stop tone controls, filters, loudness, and stereo/mono mode switches.

Metallic front panel and wooden case offer modern, elegant aesthetics matching other Pioneer gear.

Guidance on selecting and integrating Pioneer speaker systems, turntables, tuners, and tape decks.

Advice on choosing speaker systems based on impedance, sensitivity, input power, and cabinet design.

Guidance on selecting turntables based on drive system, cartridge type, and component technology.

Recommendations for choosing tuners with excellent characteristics and high stability for FM stereo.

Advice on selecting open-reel or cassette tape decks, preferably high-quality with built-in preamplifiers.

Instructions for connecting speaker plugs, observing polarity, and speaker placement for optimal stereo effect.

Details on connecting turntables with moving-magnet or ceramic/crystal cartridges to PHONO or AUX inputs.

Guide for connecting tuner output leads to the SA-600's TUNER jacks or AUX inputs.

Instructions for connecting cartridge tape player output leads to the AUX 1 or AUX 2 jacks.

Details for connecting tape deck recording input and playback output terminals to the SA-600.

Instructions for turning the unit on and off by rotating the power switch clockwise.

Description of how to adjust bass and treble levels by turning the respective controls.

Guidance on adjusting the volume balance between left and right speaker systems.

Instructions for increasing or decreasing the overall listening volume.

Explanation of how to select the program source (PHONO, TUNER, AUX) for the SA-600.

Information on using the jack for plugging in stereo headphones.

How to mute or enable speaker systems connected to sockets A and B.

Description of the STEREO and MONO settings for sound reproduction.

Explanation of LOW and HIGH filter switches to eliminate unwanted noise.

Instructions for using switches to monitor recording or playback from tape decks.

Steps to follow for playing records, including selector and volume adjustments.

Procedure for listening to radio, involving selector switch and tuning.

Guide on connecting and using a microphone with the SA-600.

Instructions for using a cartridge tape player with the amplifier.

Details on how to record signals to tape decks, noting volume control independence.

Explanation of how to monitor recording/playback using the tape monitor function.

Instructions for playing tapes back, allowing volume and tone adjustments.

Guide for transferring audio between two tape decks for duplication or editing.

List of semiconductor components used in the unit, including transistor and diode counts.

Detailed technical specifications for the power amplifier section.

Detailed technical specifications for the preamplifier section.

Details on power requirements, consumption, dimensions, and weight.