Need help?Do you have a question about the Pioneer SA-8800 and is the answer not in the manual?
General| Power Output | 60 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency Response | 5Hz to 100kHz |
| Damping Factor | 60 |
| Input Sensitivity MM | 2.5mV |
| Input Sensitivity Line | 150mV |
| Signal to Noise Ratio MM | 80dB |
| Signal to Noise Ratio Line | 100dB |
| Speaker Load Impedance | 4Ω to 16Ω |
| Dimensions | 420 x 150 x 376mm |
Controls power supply and indicates amplifier status.
Lamp indicating amplifier power status.
Selects speaker output systems (A, B, A+B).
Indicates tape monitoring function status.
Displays the rated power level on the fluorescent tube.
Lights up according to the selected function source.
Attenuates frequencies lower than 15Hz.
Attenuates frequencies higher than 8kHz.
Adjusts the output level to speakers and headphones.
Used for duplicating or editing recorded tapes.
Selects the program source for reproduction.
Selects the program source (PHONO, TUNER, AUX).
Jack for connecting stereo headphones.
Adjusts bass and treble frequencies for sound output.
Engages or disengages tone control circuits.
Balances the volume of left and right channels.
Accentuates bass and treble at low volume levels.
Attenuates audio output by 20dB.
Selects stereo, mono, or reversed stereo reproduction.
Selects input resistance and capacitance for phono cartridges.
Attenuates radio-frequency interference during record play.
Connects the first turntable's output cords.
Connects the second turntable's output cords.
Connects the tuner's output cords.
Auxiliary input jacks for various audio sources.
Allows separation of pre-amp and power amp sections.
Connects the first pair of speakers.
Connects the second pair of speakers.
Connects the ground wire of turntables, etc.
Connects the first tape deck for input/output.
Connects the second tape deck for input/output.
Spare power outlets, switched and unswitched.
Details cartridge load selection and phono interference filter.
Describes the equalization and tone adjustment circuits.
Explains amplifier circuit, power limiter, and NSA circuit.
High-speed protection circuit for power transistors.
Prevents switching distortion and reduces heat loss.
Details the fluorescent indicator tube drive circuit.
Protects speakers from DC voltage and transient operations.
Instructions for removing the outer wooden cover.
Steps to detach the bottom plate of the unit.
Procedure for removing the front panel assembly.
Identifies controls and components on the front panel.
Shows components visible after removing the front panel.
Diagrams showing component locations from top and bottom.
Procedures for adjusting DC balance and idle current.
Steps to calibrate the power output indicator.
Lists various components like capacitors, semiconductors, and switches.
Detailed circuit diagrams for the SA-8800 amplifier.
Identifies and lists parts for various P.C. boards.
Diagram and parts list for the terminal assembly.
Diagram and parts list for the switch assembly.
Schematic and parts list for the equalizer assembly.
Schematic and parts list for the filter assembly.
Schematic and parts list for the tone control assembly.
Diagram and parts list for the variable resistor assembly.
Schematic and parts list for the power amplifier assembly.
Schematic and parts list for the power supply assembly.
To Next Page
