Need help?Do you have a question about the Pioneer SA-8800/S and is the answer not in the manual?
Details power needs and cord types for different models.
Describes cabinet finishes and minor model differences.
Covers mains voltage and wiring for UK/Australia.
Explains the advanced power amplifier design.
Describes the low-distortion flat amplifier design.
Details impedance and capacitance selectors for phono cartridges.
Combines equalizer amplifier and output display.
Illustrates optimal component placement for sound quality.
Lists locations to avoid and their consequences.
Details PHONO, TUNER, AUX, TAPE, PRE OUT, POWER AMP IN jacks.
Explains speaker outputs and ground connections.
Describes spare power outlets and the main AC inlet.
How to set the voltage selector for different regions.
Illustrates overall component connections.
Details connecting left/right speakers and polarity.
Warns about polarity, impedance, and short circuits.
Explains how to strip and connect speaker wires.
How to connect turntables and ground leads.
How to connect tuners and auxiliary devices.
Connecting tape decks and specifics for HG model.
Power switch, indicators, tape monitor, filters.
Speaker selector, function indicators.
Volume, bass, and treble adjustments.
Describes the power meter.
Tape duplicate and monitor switches.
Function selector, tone switch, bass/treble.
Balance control, loudness, headphone jack.
Muting functions and stereo/mono mode selection.
Adjusting impedance and capacitance for cartridges.
Fine-tuning volume with muting switch.
Initial control setup and playing records.
Steps for using TUNER and AUX inputs.
How settings affect frequency response.
Adjusting selectors based on cartridge specs.
Table of settings for various cartridges.
How to play and record tapes.
Monitoring sound and duplicating tapes.
Connecting an external power amp to PRE OUT.
Connecting an external preamp to POWER AMP IN.
Composing multi-amp systems.
Troubleshooting steps for sound problems.
Troubleshooting steps for sound quality and feedback.
Semiconductor, power amp, frequency response, filters, hum/noise.
Input sensitivity, overload, output levels, load selectors.
Power requirements, dimensions, weight, parts.
To Next Page
General
