Pioneer SC-LX501 - Page 47

11
> Specifications > Settings > Listening Modes > Playback Function > Basic Manual
Troubleshooting | Appendix
Setting Item Default Value Setting Details
Double Bass Off This can be selected only when "System Setup" -
"Speaker" - "Configuration" - "Subwoofer" is set to
"Yes" and "Front" is set to "Large".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
•
The setting will not automatically be configured
even if you performed Full Auto MCACC.
■ Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Center 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Front Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Height Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set
in "System Setup" - "Speaker" - "Configuration"
- "Zone Speaker" and Zone 2 is on.
Height Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
•
The setting cannot be changed if "Zone 2" is set
in "System Setup" - "Speaker" - "Configuration"
- "Zone Speaker" and Zone 2 is on.
Surround Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Surr Back Right 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Surr Back Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Surround Left 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
Subwoofer 10.0ft/3.00m Specify the distance between each speaker and
the listening position.
•
Default values vary depending on the regions.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit is set as
feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1ft. When the unit is set as meters, you
can set between 0.03 m and 9.00 m in increments of 0.03 m.