Need help?Do you have a question about the Pioneer SPEC-1 and is the answer not in the manual?
General| Type | Stereo Control Amplifier |
|---|---|
| Signal to Noise Ratio (MM) | 90dB |
| Signal to Noise Ratio (line) | 110 dB |
| Total Harmonic Distortion | 0.005% |
| Total Harmonic Distortion (MM) | 0.005% |
| Total Harmonic Distortion (line) | 0.005% |
| Signal to Noise Ratio (MC) | 70dB |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Channel Separation | 70dB |
| Signal to Noise Ratio | 110dB (line) |
Advises on avoiding locations that can reduce performance or cause malfunctions.
Cautions regarding impedance, cord capacity, and connections to prevent damage.
Adjusts output level and provides attenuation for fine volume control.
Selects the desired input source for playback.
Connects microphone and adjusts mixing level with program sources.
Provides temporary volume reduction and fine attenuation steps.
Specifies initial settings for volume, tone, and switches before powering on.
Guides on selecting the function, playing records, and adjusting volume/tone.
How to mix microphone audio with a program source using the MIC MIXING control.
How to duplicate or edit tapes using the TAPE DUPLICATE switch.
Explains how VOLUME and ATTENUATOR switches combine for precise volume settings.
Checks for pilot lamp, connections, function switch, and volume/attenuator settings.
Verifies connections to SPEC-1 and the speaker switch position.
Troubleshoots microphone connection, MIC MIXING control, and howling.
Locates and explains the line voltage selector on the side panel.
Step-by-step guide to adjust the line voltage selector for different areas.
Instructions for changing fuses, including the table for fuse ratings by voltage.
To Next Page
