Need help?Do you have a question about the Pioneer VSX-D812 and is the answer not in the manual?
General| Channels | 5.1 |
|---|---|
| Power Output (8 ohms) | 100 W |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| Response Bandwidth | 10 Hz - 100 kHz |
| Built-in Decoders | Dolby Digital, DTS |
| Digital Sound Processor (DSP) | Yes |
| Tuner Bands | AM/FM |
| Tuning Range | AM: 530-1700 kHz, FM: 87.5-108 MHz |
| Preset Station Qty | 30 |
| Input Impedance | 47 kOhm |
| Audio D/A Converter | 24bit / 96kHz |
| Connector Type | RCA |
| Frequency Response | 5 Hz - 100 kHz |
| Speaker Impedance | 8-16 Ohm |
Guides through the initial setup for surround sound playback.
Details the automated setup process for speaker configuration and room settings.
Step-by-step guide for connecting digital audio/video sources.
Instructions for connecting analog audio sources like cassette decks.
Guide for connecting DVD players with multi-channel analog outputs.
Instructions for connecting various video sources to the receiver.
Wiring instructions for connecting speakers to the VSX-D712 model.
Wiring instructions for connecting speakers to the VSX-D812 model.
Identifies and describes the controls and indicators on the receiver's front panel.
Explains the various indicators and symbols shown on the receiver's display.
Details the functions of each button on the remote control unit.
Instructions for playing back multi-channel audio sources.
Explains how to enable and use the 6.1 channel surround back feature.
Details the VSB mode for creating a virtual surround back channel.
Guides the initial configuration of speaker systems and settings for optimal surround sound.
Specifies the number, type, and size of connected speakers.
Configuration for surround back speakers or subwoofer.
Determines if the subwoofer is used and its bass enhancement level.
Sets the frequency point for dividing audio signals between speakers and subwoofer.
Adjusts the attenuation level for Low-Frequency Effects (LFE) channels.
Sets the distance for the front left speaker to calibrate sound delay.
Sets the distance for the center speaker to calibrate sound delay.
Sets the distance for the front right speaker to calibrate sound delay.
Sets the distance for the surround right speaker to calibrate sound delay.
Fine-tunes speaker levels and channel delay using test tones.
Provides solutions for common operational problems and malfunctions.
To Next Page