Pioneer XDJ-RR User Manual (English)

To Next Page

Manuals+

User Manuals Simplified.

Pioneer All-In-One DJ System Instructions

Home » Pioneer » Pioneer All-In-One DJ System Instructions

XDJ-RR

ALL-IN-ONE DJ SYSTEM

pioneerdj.com/support/

rekordbox.com/

For FAQs and other support information for this product, visit the above site.

Operating Instructions (Quick Start Guide)

If you want to dispose of this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with

legislation that requires proper treatment, recovery, and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if

you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery, and recycling and thus prevent potential negative eﬀects on the environment and

human health.

K058b_A1_En

CAUTION

TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.

D3-4-2-1-1_B1_En

WARNING

This equipment is not waterproof. To prevent a ﬁre or shock hazard, do not place any container ﬁlled with liquid near this equipment (such as a vase or ﬂower pot) or expose it to dripping,

splashing, rain, or moisture.

D3-4-2-1-3_A1_En

WARNING

To prevent a fire hazard, do not place any naked flame sources (such as a lighted candle) on the equipment.

D3-4-2-1-7a_A1_En

Operating Environment

Operating environment temperature and humidity: +5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH (cooling vents not blocked) Do not install this unit in a poorly ventilated area, or in

locations exposed to high humidity or direct sunlight (or strong artificial light).

D3-4-2-1-7c*_A2_En

VENTILATION CAUTION

When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 5 cm at the rear, and 5 cm at each side).

D3-4-2-1-7d*_A1_En

This product is for general household purposes. Any failure due to use for other than household purposes (such as long-term use for business purposes in a restaurant or use in a car or

ship) and which requires repair will be charged for even during the warranty period.

K041_A1_En

POWER-CORD CAUTION

Handle the power cord by the plug. Do not pull out the plug by tugging the cord and never touch the power cord when your hands are wet as this could cause a short circuit or electric shock.

Do not place the unit, a piece of furniture, etc., on the power cord, or pinch the cord. Never make a knot in the cord or tie it with other cords. The power cords should be routed such that they

are not likely to be stepped on. A damaged power cord can cause a ﬁre or give you an electrical shock. Check the power cord once in a while. When you ﬁnd it damaged, ask your nearest

service center or your dealer for a replacement.

S002*_A1_En

CAUTION

Need help?

Do you have a question about the Pioneer XDJ-RR and is the answer not in the manual?

Pioneer XDJ-RR Specifications

Power

power requirements	AC 100 V to 240 V, 50 Hz/60 Hz
rated current	0.9 A
rated output	DC 12 V, 3 A
power consumption (standby)	0.4 W
power consumption	DC 12 V, 2 500 mA

Operating Environment

tolerable operating temperature	+5 °C to +35 °C
tolerable operating humidity	5 % to 85 % (no condensation)

Audio Specifications

sampling rate	44.1 kHz
A/D, D/A converter	24-bit
frequency characteristic (USB, AUX, MIC)	20 Hz to 20 kHz

S/N Ratio

USB S/N ratio	112 dB
AUX (LINE) S/N ratio	96 dB
AUX (PORTABLE) S/N ratio	90 dB
MIC S/N ratio	81 dB

Total Harmonic Distortion

USB total harmonic distortion	0.003 %

Input Impedance

AUX (LINE) input impedance	–12 dBu/47 kW
AUX (PORTABLE) input impedance	–24 dBu/47 kW
MIC input impedance	–57 dBu/3 kW

Output Impedance

MASTER 1 output impedance	+6 dBu/10 k W/390 W or less
MASTER 2 output impedance	+2 dBu/10 k W/1 k W or less
PHONES output impedance	+8 dBu/32 W/1 W or less

Rated Output Level

MASTER 1 rated output level	+24 dBu/10 k W
MASTER 2 rated output level	+20 dBu/10 k W

Channel Equalizer Characteristic

HI channel equalizer characteristic	–∞ dB to +6 dB (20 kHz)
MID channel equalizer characteristic	–∞ dB to +6 dB (1 kHz)
LOW channel equalizer characteristic	–∞ dB to +6 dB (20 Hz)

Microphone Equalizer Characteristic

HI microphone equalizer characteristic	–12 dB to +12 dB (10 kHz)
LOW microphone equalizer characteristic	–12 dB to +12 dB (100 Hz)

Input / Output Terminals

MIC input terminal	XLR connector & 1/4” TRS jack, 1 set
AUX input terminal	RCA pin jacks, 1 set
MASTER 1 output terminal	XLR connector, 1 set
MASTER 2 output terminal	RCA pin jacks, 1 set
PHONES output terminal	1/4” stereo phone jack, 1 set
USB terminals	A type, 2 sets; B type, 1 set; Power supply: 5 V/1 A or less

Weight and Dimensions