10 Using Sound Modes
51
En
English
S.M.JOG
EQUALIZER
ZOOM SURROUND
P.BASS(DEMO)
SET
BASS BLASTER mode
Bass Blaster produces a powerful, pumping bass sound.
Press BASS BLASTER (main unit) to switch on/off as required.
Memorizing your own settings
You can memorize up to three different combinations of Equalizer, Zoom Surround,
and P.Bass settings. Access them from the PRESET mode (see the previous page).
Note: if the unit is unplugged from the power supply, settings will remain intact for
several days, after which they are lost.
1 Adjust the EQUALIZER, ZOOM SURROUND
and P.BASS to your liking.
Note: the Bass Blaster setting is not stored as a user preset.
2 Push and hold the SET button for about three
seconds.
USER 1 flashes in the display
3 Select USER 1, 2 or 3 by turning the S.M. JOG.
4 Push the SET button again to store the settings.
Changing the sound display
There are six different sound level displays on the main unit. Use the DISPLAY button
(DISP on the remote) and the S.M.JOG dial/JOG buttons to switch between them.
1 Press DISP (DISPLAY on the front panel) until
the main unit’s display reads DISP.
2 Use the S.M.JOG dial/JOG buttons to cycle
through the six different display types.
Stop on one you like.
S.M.JOG
DISPLAY
To Next Page
Loading...
Need help?
General
