CHEROKEE
180
SECTION III
6.
When the
engine
fires,
advance throttle to desired
setting.
If
the engine does not fire within five
to ten
seconds,
disengage starter and
prime with
one
to three strokes
of the
priming pump. Repeat
the
starting
procedure.
Starting
Engine When Hot:
1.
Open the throttle approximately 1/2 inch.
2. Turn
the master
switch ON.
3.
Turn the
electric
fuel
pump
ON.
4.
Put mixture control in IDLE
CUT-OFF.
5. Engage the
starter
by rotating magneto switch
clockwise and
pressing in.
When
the engine fires, advance the mixture
control and
move the throttle to desired setting.
Starting
Engine When
Flooded:
1. Open the throttle
full.
2. Turn
the
master switch
ON.
3.
Turn the
electric
fuel pump OFF.
4.
Put mixture
control
in
IDLE
CUT-OFF.
5. Engage
the starter
by
rotating magneto switch
clockwise
and
pressing
in.
When
the
engine fires, advance the
mixture control and
retard the
throttle.
Starting
With External Power Source:
An
optional
feature
known as Piper External
Power
(PEP)
allows
the operator
to
use an external
battery
to crank the engine
without
having
to
gain access to
the aircraft battery.
The procedure is as
follows:
1.
Turn aircraft MASTER SWITCH to OFF.
2. Connect RED lead
of
PEP
kit
jumpercable to
POSITIVE
(+)
terminal of
external 12 volt
battery
and BLACK lead to
NEGATIVE
(-)
terminal.
3.
Insert
plug
of
jumper
cable into
socket located
on
aircraft
fuselage.
4. Turn aircraft MASTER SWITCH
to
ON
and proceed with
NORMAL
engine starting
technique.
761
513
21
720615
To Next Page
Loading...
