How to fix Pit Boss 757GS Griddle burner that will not light?
If your Pit Boss Griddle burner won't light, there are a few things to check. First, ensure that gas is being supplied by checking the regulator valve and connection for any leaks. If there's still no igniter spark on the electrode, try adjusting the electrode. If the ignition wire is broken, contact Customer Service for assistance or a replacement part.
What to do if my Pit Boss 757GS has low heat on “HIGH”?
If you're experiencing low heat on “HIGH” on your Pit Boss Griddle, try clearing the ports of any obstructions. Also, make sure that the gas tank is not empty and refill it if necessary.
What to do if I notice gas leakage from my Pit Boss 757GS?
If you notice gas leakage from your Pit Boss Griddle, immediately turn the regulator knob to the OFF position, allowing it to pop out, and remove the gas cylinder. Re-install and tighten the cylinder, then perform a leak test to ensure a proper seal. Replace the gas cylinder if it's damaged, corroded, rusted, or has been mishandled. If the regulator has failed, contact Customer Service for a replacement part.
Why does the burner on my Pit Boss 757GS keep blowing out?
If the burner on your Pit Boss Griddle blows out, first check the gas fuel connection to ensure it's open and replace the gas cylinder if it's empty to ensure proper gas flow. If you're experiencing gusting or high winds, turn the front of the grill away from the wind or increase the flame height.
Why are the burner flames yellow or orange on my Pit Boss 757GS Griddle?
If the burner flames on your Pit Boss Griddle are yellow or orange, it could be due to several reasons. Check the burner tube and burner ports for spider webs or other obstructions that may be causing poor air flow, and follow the Care and Maintenance instructions to clean the burner tube. Ensure the regulator valve connection to the gas cylinder is correct by removing and reinstalling it, then perform a leak test. Also, turn the regulator knob to HIGH for five minutes to burn off any dirt on the burner, and follow the Care and Maintenance instructions. Make sure the grease cup isn't full and spilling; empty and reinstall it.
Dangers and warnings related to gas leaks, flammable liquids, and LP cylinder storage.
Requirements for installation conforming to local and national fuel gas codes.
Warnings concerning propane gas cylinder handling, filling, and condition.
Information and guidelines on the dangers of carbon monoxide poisoning.
Instructions for removing rubber feet from the hot plate.
Steps to unlock and expand the griddle cart legs for assembly.
Instructions on securing the cart legs and bottom shelf with bolts.
Guide for attaching side shelf brackets to the firebox.
Steps to mount and secure the side shelves onto the griddle.
Instructions on how to place the grease cup into its housing.
Steps for attaching the control knobs to the front panel.
Guide for correctly positioning and securing the gas cylinder.
Specifies requirements for the LP gas cylinder and regulator.
Step-by-step instructions for installing the gas cylinder.
Procedures for safely disconnecting the gas cylinder.
Guidance on setup location, cold, and hot weather cooking.
Procedure for performing a leak test on gas connections before use.
Lists required supplies and steps for conducting a gas leak test.
Step-by-step guide on how to light the griddle burners safely.
Troubleshooting steps if the igniter fails to spark or light the burner.
Alternative method for lighting the griddle using a match.
Instructions for safely turning off the griddle and disconnecting the gas.
Method to check the remaining fuel level in the LP gas cylinder.
Guidelines on how often to clean different components of the griddle.
Recommendations for safe food handling, cooking, and storage.
Tips for preparing ingredients and having everything ready before cooking.
Advice on using thermometers, resting meat, and proper turning techniques.
Terms and conditions of the limited warranty for the griddle.
Situations and damages not covered by the product warranty.
Information on how to obtain warranty service and record model/serial numbers.
To Next Page
General
