To Next PageTo Next PageHow do I fix the "Er1" error code on my Pit Boss Grill?
If you're seeing an "Er1" error code on your Pit Boss Grill, it indicates that the grill probe wire is not making a proper connection. To address this, remove the hopper access panel and check the grill probe wires for any damage. Also, ensure that the grill probe connectors are firmly and correctly connected to the control board.
What does flashing temperature on LCD screen mean for Pit Boss Grill?
A flashing temperature on the LCD screen of your Pit Boss Grill indicates that the grill temperature is below 65°C / 150°F. This isn't necessarily an error, but it suggests a risk that the fire could go out. Check the hopper to ensure there's sufficient fuel and inspect the feed system for any obstructions. Remove the pellets and follow the Care and Maintenance instructions. Also, check the grill probe, burn pot, and fan for any issues, following the Care and Maintenance instructions as needed. Finally, confirm that the auger motor is operating correctly and that there are no blockages in the auger tube.
What do flashing dots on the Pit Boss Grill LCD screen mean?
The flashing dots on the LCD screen of your Pit Boss Grill simply indicate that the igniter is on and the unit is in Start-Up mode. This is not an error. The igniter will turn off after five minutes, and once the flashing dots disappear, the grill will begin adjusting to the selected temperature.
What does ErP error code mean on a Pit Boss smoker?
If your Pit Boss smoker displays the ErP error code, it means the unit was not turned off properly when last connected to power. This safety feature prevents an automatic restart. Press the power button to turn the unit off, wait two minutes, and then press it again to turn the unit back on. Turn the temperature control dial to smoke or the desired temperature. If the error code persists, contact Customer Service.
General
