14 Factory Reset
14.1 Digital Settings Factory Reset:
Press and hold [Hold Button], [Arpeggiator Button], and [Dynamics Mode Button] for 5 seconds
to reset all digital modes and functions to the default settings. This action can not be undone.
15 Paraphonic Calibration
15.1 Calibrating Velocity Output for Paraphonic Mode:
The [Velocity Output Jack] needs to be calibrated to output the correct offset voltage for
Paraphonic Mode. The calibration procedure is simple and results are saved when Taiga is
powered off.
1.Turn up the volume for oscillator 1 and oscillator 2. Oscillator 3 is not needed so turn the
volume of oscillator 3 full left to off.
2. Make sure the Oscillators 1 and 2 are in tune with each other when a note is played. A tuner
can be used for more precision.
3. Enter Paraphonic Mode by pressing [Velocity/CV Mode Button] to cycle through the 4
options until 2 Voice Paraphonic Mode is selected. The velocity mode can only be changed
when arpeggiator mode is NOT active.
Velocity Output Options
Pseudo-Random Shift Register Mode (more chance)
Pseudo-Random Shift Register Mode (small chance)
2 Voice Paraphonic Mode (Patch cable needed. See 5.22)
(All LEDs Off) MIDI Note Velocity 0v to 5v Output
4. Enable Hold Mode by pressing the [Hold Button].
5. Play a C note and then a higher C note on a MIDI keyboard. If the higher note sounds sharp
or at compared to the lower note, proceed to the next step.
6. Press and hold the [Edit Button] then press the [Hold Button]. Use the modulation wheel to
adjust the frequency of the higher oscillator. When the oscillators are in tune with each other,
the calibration procedure is nished.
To Next Page
Loading...
