Page 3For technical questions, please call 1-888-866-5797.68892
IMPORTANT SAFETY INSTRUCTIONS
1. Study, understand, and follow all instructions
before operating this device.
2. Do not exceed rated capacity.
3. Use only on a hard, level surface
capable of supporting the load.
4. Center load on lift platform.
5. Lift only those areas of the vehicle
specified by its manufacturer.
6. Immediately after lifting load, ensure lift
mechanical load holding means is engaged.
7. Before moving, lower the load to
the lowest possible point.
8. Secure load with appropriate restraint device.
9. Failure to heed these markings may result in
personal injury and/or property damage.
10. Use of this product is limited to lifting, lowering,
transporting, and storing, in the lowered
position, loads consisting of a single vehicle
whose lift points are compatible with the lift
platform. Incompatibility is evident when the
loaded vehicle wobbles, appears unstable, and/
or does not securely engage the lift platform.
11. Restraining an incompatible load will not make the
load secure and may cause unexpected loss of load.
12. Never work on, around, or under a load
that is not secured and stable.
13. Keep operator’s and bystander’s head, hands, and
feet away from lift arms when raising and lowering.
14. No alterations shall be made to this product.
15. Only attachments, restraints, or adapters
supplied by the manufacturer shall be used.
16. Do not adjust safety valve.
17. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
18. Lower load slowly.
19. Do not use for aircraft purposes.
20. Apply parking brake and chock tires
before lifting vehicle.
21. Inspect before every use;
do not use if parts are loose or damaged.
22. Do not lift motorcycle with rear tire on ramp.
23. Keep work area clean and well lit. Cluttered
or dark areas invite accidents.
24. Keep children and bystanders away while operating.
Distractions can cause you to lose control.
25. Stay alert. Watch what you are doing, and use
common sense when operating. Do not use while
tired or under the influence of drugs, alcohol,
or medication. A moment of inattention while
operating may result in serious personal injury.
26. Store idle lifts out of the reach of children and do
not allow persons unfamiliar with the lift or these
instructions to operate it. Lifts are dangerous
in the hands of untrained users.
27. Have your lift serviced by a qualified repair person
using only identical replacement parts. This will
ensure that the safety of the lift is maintained.
28. Maintain labels and nameplates on the lift. These
carry important information. If unreadable or missing,
contact Harbor Freight Tools for a replacement.
29. Read lifting requirements in service
manual of the motorcycle being lifted.
30. Industrial applications must follow
OSHA requirements.
31. Do not allow anyone on the lift or the
motorcycle/ATV while on the lift.
32. Raise Casters off the ground to prevent movement
before loading, unloading, raising, or lowering.
33. Before lowering, remove all tools and
equipment from under lift.
34. Only use this lift to raise a motorcycle or an ATV to
perform maintenance. Do not attempt to transport
or relocate motorcycle/ATV while on the Lift.
35. The warnings, cautions, and instructions discussed
in this instruction manual cannot cover all possible
conditions and situations that may occur. It must
be understood by the operator that common sense
and caution are factors which cannot be built into
this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
