Page 8 For technical questions, please call 1-888-866-5797. 68892
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected
before further use. Lock the lift with the Locking Bar before servicing in the raised position.
1. Before each use, inspect the general condition of
the Lift. Check for broken, cracked, or bent parts,
loose or missing parts, and any condition that
may affect the proper operation of the product.
If a problem occurs, have the problem corrected
before further use.
Do not use damaged equipment.
2. If the Lift appears not to be working
properly, follow Bleeding instructions.
3. The mechanical parts of the Lift, such as
the pedal lift and release shafts should be
occasionally lubricated with heavy oil or grease.
4. Protect the Lift Cylinder from dirt or grit when
in the raised position. If it becomes dirty, wipe
it off with a clean cloth before lowering.
5. Maintain and store the Lift in a reasonably
protected environment. Do not expose to rain
or excess moisture. Protect from salt water or
other corrosive materials. If it becomes dirty or
contaminated, clean it promptly with clean water or
a suitable detergent. If using a pressure washer,
be aware that you may remove some paint from
the outer surface. Never spray a pressure washer
at the seal areas near the pistons or valves.
Lubricate external moving parts after cleaning.
6. If the lift slowly lowers on its own, it may
have damaged seals or insufficient oil.
First check the oil level. If the level is OK, take
the lift to a qualified service technician for seal
replacement. Damaged seals may be caused by
overloading, or exposure to harmful conditions
or inappropriate use of a pressure washer.
NOTE: If the lift can be raised to its highest position,
it indicates that there is enough oil.
If the lift slowly lowers from this position, it indicates
that the problem is likely with the seals.
NOTE: Do not tamper with the check valves. Any
repairs should be performed by a qualified technician.
To Next Page
Loading...
