Page 9For technical questions, please call 1-888-866-5797.68892
Checking and Filling Hydraulic Fluid
1. Lower the lift completely. Remove the Access Panel
and the Oil Plug on the side of the Jack underneath.
2. The oil level should be even with the bottom of the
filler plug hole. You should be able to see the oil.
3. If the oil level is low, add SAE Hydraulic Jack
fluid only. Avoid mixing different brands of oils.
Do not use any other fluid or brake fluid.
Bleeding
Note: If the Lift appears not to be working properly, it may be necessary
to bleed trapped air from its hydraulic system.
1. Check oil level. Replace plug.
2. Depress Release Pedal.
3. Pump the Foot Pedal several times.
4. Let up on Release Pedal.
5. Pump Foot Pedal.
If the motorcycle lift does not elevate smoothly or
Foot Pedal feels “spongy”, repeat steps 2 - 5.
To Next Page
Loading...
