Page 7For technical questions, please call 1-888-866-5797.68892
Lowering
1. Remove all tools, parts, etc. from under the vehicle.
2. Slightly raise the platform to free the Locking Bar.
3. Remove the Locking Bar, then slowly press
the Release Pedal to ease down the unit.
NOTE: The speed of lowering is controlled
by the Release Pedal. Operate this Pedal
slowly in a controlled and safe manner.
4. After lowering, open the Vise and
remove the motorcycle from the lift.
5. Turn the Lifting Screws counterclockwise
to lower the lift onto the Casters.
6. Store in a safe, dry location out of reach of children.
Small ATV Application
1. The Lift can be used to support small ATV’s
under certain conditions. A small ATV can be
rolled onto the Lift if the wheel width of the ATV
falls within the 26-3/4" width of the Lift’s platform.
Never attempt to ride an ATV onto the platform.
The Lift should not be used to support
an ATV unless all 4 tires of the ATV can
completely rest on the platform.
2. Use at least 2 wheel chocks (one for a front
ATV wheel and one for a back ATV wheel) to
prevent movement of the ATV while it is being
worked on. Wheel chocks sold separately.
3. Before lifting, secure the ATV to the Lift
using tie down straps (not included).
To Next Page
Loading...
