Piusi CUBE 70 MC - Description of Main Components; Core Components Overview; Optional and Accessory Components

41
/124
41 /64
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
EN (translated from italian)
CUBE • MC
3
APPLY THREAD
SEALER AT THE
POINTS SHOWN
IN THE PHOTO,
BEFORE PRO-
CEEDING WITH
FINAL ASSEM-
BLY
8 MACHINE AND MANUFACTURER IDENTIFICATION
The SELF SERVICE stations feature an identification plate that is attached
to the shell showing
- Model
- Serial number / Year of manufacture
- Technical data
- EC mark
- Instruction manual code
ATTENTION
Before installing the unit, check that the model is right and suitable for
currently available supply voltage and frequency
8.1 PLATES POSITIONS
The dispensing system is equipped with decals and/or plates to provide
operators with the necessary important information. Make sure that these
do not deteriorate or become detached over time.
NOTE
Should this situation arise, please contact our support department and
arrange to have the damaged or missing plates sent back and replaced
where necessary.
The decals present are as follows:
ON
OFF
- Pump activation plate