Piusi CUBE 70 MC - Special Maintenance

57
/124
57 /64
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
EN (translated from italian)
CUBE • MC
PULSER The meter / pulser is a carefully-made and assembled high-precision measur-
ing instrument. It normally requires no routine maintenance.
CALIBRATION, normally done during station installation, can be repeated
whenever accuracy checks, to be performed every 3/6 months, show the
need.
CALIBRATION is done electronically by means of the MC control system,
and does not require any adjustments to be made to the pulser. For all details,
refer to the K600 meter manual.
16.2 SPECIAL MAINTENANCE
In order to change the fuses inside the electronic board panel, we suggest
proceeding as follows:
- Interrupt power to the CUBE MC
- Remove the cover of the MC BOX panel
- Replace the burnt out fuses
- Close the panel again
- Restore power to the CUBE MC
POWER SUPPLY UNIT FUSE
-100 mA FOR VERSION
230V/50Hz
- 200 mA FOR VERSION
110V/60Hz
MOTOR FUSES - 8A