Pixsys ATR 121 - Page 40

39
20 - MEMORY CARD (OPTIONAL)
Parameters and setpoint values can be easily copied from one
controller to others using the MEMORY CARD. The controller
must be switched-off before entering the Card. Check also
entry direction (components must be turned towards front
panel).
Switching-on the controller, display will show
3
.
Press Display Do
1
shows ,
shows .
Select (Memo
load) to store values
of Memory on the
controller.
Select to keep
values of the
controller unchanged.
2
The controller stores
value and restarts.
Updating values of memory
card
To update values of Memory card
follow the above proceedings,
selecting on display, so
values of memory will not be stored
on the controller
4
. Enter
configuration mode, modify at
least one parameter and exit.
3
Only if values stored on Memory Card are correct.
4
If the controller does not visualize at starting, this
40
20.1 Memory C.243 with battery (OPTIONAL)
With the controller not connected to power supply.
The memory card is equipped with an internal battery with an
autonomy of about 1000 uses.
Insert the memory card and press the programming buttons.
When writing the parameters, the led turns red and on
completing the procedure it changes to green. It is possible to
repeat the procedure without any particular attention.
means that no values are stored on Memory Card, but they
may be copied and updated.