Pknight WIFI-DMX Easynode PLUS - Customizing WiFi Name and Password

Pknight
®
WiFi-DMX EasyNode Manual Page 9
Pknight
®
WiFi-DMX EasyNode Manual Page 10
Pknight® WIFI-DMX EasyNodePknight® WIFI-DMX EasyNode
Setting Multiple modes
1
4
If you want to connect an external router,
you need to enter the router's WiFi name
and password, and not only that, you need
to make sure the checkbox( ) is not
checked if you want to make this connection
take effect.(used only in router mode)
4
Check the independent mode to disable
the router's WiFi connection and allow data
to be received through its own hotspot.
Usually, we use it as a switch to disconnect
the router’s WiFi and use its own hotspot to
connect with other devices.
2
Here is the controller itself WiFi or hotspot
information, it can be customized, The
network name can be 1-32 characters
in length and the password can be 8-16
characters in length. Only alphanumeric
characters or space characters are allowed.
If you forget the WiFi password, you
can go back to page 5 and refer to
the function button to restore factory
settings.
3
If the wifi of the external router cannot be
connected, the hotspot will start after a delay
of 25 seconds. It can also be customized.
Turn off the power and then turn it
back on for the changes to take effect.
Easylink mode
Phone or tablet...
Unlimited number
connected
connected connected
connected
connected