Need help?Do you have a question about the Plane-Power R1224 and is the answer not in the manual?
General| Brand | Plane-Power |
|---|---|
| Model | R1224 |
| Category | Controller |
| Language | English |
General information pertaining to airworthiness limitations for the regulator.
Statement regarding FAA acceptance and maintenance requirements for airworthiness limitations.
Details on life limits for component parts and the R1224 series regulators.
Provides general information about the installation instruction document and its purpose.
Outlines the guidelines and standards followed in this installation instruction.
States that measurements are taken from original manufacturing drawings.
Lists SI units and their definitions used within the instruction.
Provides a list of abbreviations used throughout the instruction manual.
Defines warnings, cautions, notes, and technical terms used in the instruction.
Instructions for the proper disposal of unairworthy parts and assemblies.
Guidelines for storing the regulator when unused or after installation.
Explains the format and meaning of the regulator's serial number.
Details the limited warranty offered by Hartzell Engine Technologies LLC for the regulator.
Provides an overview of the R1224 Voltage Regulator's features and design.
Describes the function and connection of each terminal on the regulator's connection strip.
Explains how the regulator functions in field-drive, overvoltage protection, and dual alternator modes.
General guidance on troubleshooting regulator malfunctions and taking corrective action.
Provides a warning and note regarding troubleshooting procedures and safety precautions.
Details the steps and conditions for testing the R1224 regulator.
Defines the checks and inspections needed for reliable alternator operation.
Lists specific inspection checks and their frequency (e.g., 100 hours TIS).
Guidance on performing tests and checks according to manuals or Table 3.1.
General information on identifying aircraft models and OEM part numbers for regulator replacement.
Step-by-step instructions for installing the regulator on single-engine aircraft.
Instructions for installing regulators on multi-engine aircraft, covering master/slave configuration.
Specific installation steps for aircraft using 3 color-coded wires for regulator connection.
Specific installation steps for aircraft using 3 color-coded wires, with a blue field wire.
Installation guide for aircraft using 5 color-coded wires and an adapter plate.
Installation guide for Ford regulators, involving cutting plug and using adapter plate if needed.
Installation guide for Beechcraft regulators with a round connector, using a specific installation aid.
Installation guide for dual regulators using adaptor plates, covering wiring and lamp modification.
Installation guide for regulators connected via screw terminals, requiring drilling new mount holes.
Installation guide for Lamar regulators, requiring replacement of both units and setting master/slave.
Instructions for preparing and replacing the regulator using a mounting plate and specific wiring connections.
Installation guide for AG-5B regulators, involving a 4-pin plug and ground wire, with lamp modification.
Installation guide for replacing Lamar regulators with two R1224B regulators, covering wiring and master/slave setup.
Instructions for replacing Lamar regulators, involving jumper removal and specific wire connections.
Installation guide for InterAv regulators, including over voltage relay removal and wiring.
Instructions for replacing Jasco regulators, including jumper addition and voltage adjustment.
To Next Page