Page 3 Page 8
2) AF [ALTERNATIVE FREQUENCIES]
When AF switching mode is selected and the state of AF switching mode is
displayed by AF segment in display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not
received yet.
When AF switching mode is selected, the radio checks the signal strength of
AF all the time. The interval of checking time of each AFs depends on the
signal strength of current station, from a few minute for strong station to a few
seconds for weak station. Every time that new AF is stronger than current
station, it switches over to that frequency for very short time, and
NEW FREQUENCY is displayed for 1-2 seconds. Because the mute time of AF
switching or checking time is very short, it is almost inaudible in case of
normal program.
During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can
only receive and save RDS program.
3) TA SEEK/TA ALARM:
TA SEEK mode: when newly tuned station does not receive TP information for
5 seconds, the radio retunes to next station which has a different PI to the last
station, but has the TP information.
When TP information gets lost at the current station for retune time which is
set by RETUNE SHORT(90 seconds) or RETUNE LONG(150 seconds), the
radio starts to retune to next same PI station. When same PI station does not
receive in 1 cyclic search, the radio retunes to next station with TP information.
TA ALARM mode: when this mode is selected, any automatic retune mode is
not activated. Only double beep sound(ALARM) will be heard.
When newly tuned station does not have TP information for 5 seconds, beeps
are sounded.
When TP information gets lost at the current station for retune time, the beep
sound will be heard.
When newly tuned station has no RDS signal, PI SEEK is suppressed .
4) PI SOUND/ PI MUTE:
PI SOUND mode: if a car cruises between buildings that could cause
reflecting signals, a phenomenon may occur, due to different PI codes being
received from the same AF source. when different PI sounds (DIP) are heard
occassionally, this will happen for less than 1 second.
PI MUTE mode: under above same situation, a mute sound will be heard for
less than1second.
5) RETUNE L / RETUNE S:
The initial time of automatic TA search or PI SEARCH mode is selected.
When PI information is not received for retune interval , the radio starts to
retune to next same PI station.
When same PI station does not receive 1 cyclic search, the radio goes to last
station and waits for 4-5 minutes until PI code is received.
RETUNE L mode: selected as 90 seconds.
RETUNE S mode: selected as 60 seconds.
An insulation tag was installed in your remote by the manufacturer to prevent the
battery from draining. Removing the tag from the remote before using.
BATTERY INFORMATION:
Lithium Battery: CR2025 3V
Battery Life: Approximately 6 months.
Replacing the Battery from the Remote Controller:
1) Remove the battery holder by pressing the locking tab with your thumb
and pulling it out.
2) Replace the battery with the same type and the “ side facing up.
3) Gently push in the holder until securely locked into place.
WARNING:
+”
Do not recharge, disassemble or dispose of in fire.
Battery leakage may cause damage to the unit.
To avoid the risk of accident, keep batteries out of reach of children.
MAINTENANCE OF REMOTE CONTROL
To Next Page
Loading...
Need help?
General
