1080p IR Bullet PoE IP Camera
ICA-3460V
- 52 -
1. Make sure that the firmware only applies to this device; once updated, it will be
burned into FLASH ROM of system.
2. The firmware upgrade procedure cannot be interrupted. If the power and/or
network connection are/is broken during the download procedure, it might
possibly cause serious damage to the device.
Please be aware that you should not turn off the power during updating the
firmware and waiting for the “finish” message. Furthermore, do not try to
upgrade new firmware if necessary.
3.8.2 Reboot System
The device is restarted without changing any of the settings.
3.8.3 Factory Default
Clicking the Restore button will reset all devices’ parameters to the factory settings (including
the IP address).
3.8.4 Backup
Recovery
Click the “Recovery” button to locate the saved backup file and
open the backup file. The settings will be restored to the previous
configuration.
To Next Page
Loading...