WGS3 Layer 3 Switch User’s Manual
- 36 -
Saving and restoring switch configuration settings can be initiated by using any TFTP client utility, such
as the command line utility included in Windows NT/2000/XP. For example, using Windows NT, from a
DOS window command prompt, enter the TFTP command in the form:
TFTP [-i] host [GET : PUT] source [destination]
To transfer a file –
On Switch: Specify the IP address of the TFTP client, and select “Download from switch” or “Upload to
Switch.” Then select <Start> from the menu to start.
On TFTP Client: Set the mode to <binary>, specify the IP address of the target switch and the directory
path / name of the file to transfer. Then start transferring the configuration from the TFTP client or the
switch and wait until the transfer completes.
For example, type “tftp -i 203.70.249.118 GET source wgs3.txt” on Windows 2000’s command prompt to
download switch’s configuration and type “tftp –i 203.70.249.118 PUT wgs3.txt” to upload the
configuration file to switch.
To Next Page
Loading...