EasyManua.ls Logo

Planet Networking & Communication WGS3-2620 - Chapter 1. Introduction; Features

Default Icon
267 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
WGS3 Layer 3 Switch User’s Manual
- 1 -
Chapter 1. Introduction
Both WGS3-404 and WGS3-2620 are IP-based Layer 3 Gigabit Ethernet Switch. WGS3-404 is with
4-port 10/100/1000Mbps and 4-slot for 1000Base-T and 1000Base-SX modules. WGS3-2620 is with
24-port 10/100Mbps and 2-port 1000Mbps switches.
The 2 and four RJ-45 gigabit copper ports support 10/100/1000Mbps auto-MDI/MDI-X detection that can
directly connect to any Gigabit Ethernet Servers, Switches, L3 backbone with a straight Category 5/5e,
8-wire UTP cable.
The wire-speed switch engine provides up to 8.53 and 16Gbps switch fabric for L2 and L3 IP routing
capability. Up to 256 IP subnet / L2 tagged VLAN are also available to segment the IP or MAC-based
networks. IEEE802.1D Spanning Tree, bridging, Port mirroring and port trunking also support for optimal
LAN connection and diagnose. IGMP snooping, filtering, dual priority helps to build a multimedia
networks like video-conference etc.
Designed to offer the guaranteed IP Layer 3 routing with RIP, OSPF and DVMRP support, the
WGS3-404 and WGS3-2620 empower the performance of pure IP-based network easier then ever.
1.1 Features
WGS3-404 is with 4-port 10/100/1000Mbps and 4-slot for 1000Base-SX, 1000Base-T modules.
WGS3-2620 is with 2-port 1000Mbps, 24-port 10/100Mbps Ethernet Switch
Complies with IEEE 802.3, 10Base-T, IEEE 802.3u, 100Base-TX, IEEE 802.3z, 1000Base-SX
and IEEE 802.3ab, 1000Base-T standards
IEEE 802.3x, full-duplex flow control compliant; back-pressure half-duplex flow control
IEEE 802.1p, dual priority; IEEE802.1Q, VLAN Tagging; IEEE802.1D Bridging compliant
32K MAC address table auto-ageing / 64K IP address at most
IPv4 Layer 3 routing, supporting RIP-1/2, OSPF, DVMRP (Distance-Vector Multicast Routing
Protocol)
8.53G/19.2G non-blocking, Store and Forward switching architecture
RS-232 console interface for console program managements, Web / Telnet Support
Port-based Trunking support increase the bandwidth between switches (2/4/8-port in one trunk)
255 port-based VLANs eliminate the broadcast-packet, increase the LAN security for different
segments
IGMP multicast snooping and filtering
Port mirroring for port traffic diagnose with sniffer programs
RMON group 1, 2, 3, 9 support
19”, 1U height rack mounting
100~240VAC, 50~60Hz universal Power input
FCC, CE class A compliant

Table of Contents