Planet Networking & Communication WGS3-2620 - IP Filtering Configuration

To Next Page

To Previous Page

WGS3 Layer 3 Switch User’s Manual

- 91 -

4.5.7.2 IP Filtering Configuration

If any node presents a security risk, you can filter all traffic for this node by entering its address into the

IP Security Filtering Configuration. Any packet passing through the switch that has a source or

destination IP address matching an entry in this table will be filtered.

NOTE: To add a IP address to the security filter, use <Add>. To delete an address, highlight it with the

cursor and select Enter. Use the <Next Page> and <Prev Page> buttons to scroll through the

table. To display a specific page, set the page number in the Page field and then press <Apply>.

To add an entry, press <Add>.