WGS3 Layer 3 Switch User’s Manual
- 90 -
4.5.7.1 Configuring MAC Address Filters
Any node that presents a security risk or is functioning improperly can be filtered from this switch. You
can drop all the traffic from a host device based on a specified MAC address. Traffic with either a source
or destination address listed in the Security Filtering Configuration table will be filtered.
NOTE: To add a MAC address to the security filtering, use <Add>. To delete an address, highlight it
with the cursor and press Enter. To scroll through the address table, use the <Next Page> and
<Prev Page> buttons. To display a specific page, set the page number in the Page field and
then press <Apply>.
To Next Page
Loading...