720p SIP Multi-unit Video Door Phone with RFID and PoE
HDP-5240PT
31
Chapter 4. Basic Operation
4.1 Answer a Call
When a call comes in, the device would answer automatically. If you cancel auto answer feature and set auto
answer time, you would hear the ring at the set time and the device would auto answer after configuring the
timer.
4.2 Call
Configure the shortcut key as hot key and then set up a number; after that you might press the shortcut key
for making a call to the configured extension(s).
4.3 End Call
Enable the Release (You can enable release) key for hanging up feature to end call.
4.4 Open the Door
You might open door through the following seven ways:
A. Input password on the keyboard to open the door.
B. Have access to calling the owner and the owner enters the remote password to open the door.
C. Owner/other equipment accesses control and enter the access code to open the door. (access code
should be included in the list of access configuration, and enabled for remote calls to open the door)
D. Swipe the RFID cards to open the door.
E. Use the indoor switch to open the door.
F. Use private access code to open the door.
Enable for local authentication, and set private access code. Input the access code directly in standby
mode to open the door. In this way, the door log would record corresponding card number and user name.
G. Active URL control command to open the door.
URL is “http://user:pwd@host/cgi-bin/ConfigManApp.com?key=F_LOCK&code=openCode”
(A) User and pwd are the user name and password of logging on to web page.
(B) “openCode” is the remote control code to open the door.
For example, “http://admin:admin@172.18.3.25/cgi-bin/ConfigManApp.com?key=*”
To Next Page
Loading...
Need help?
General
