1. Package Contents
Note
– 1 – – 2 –
– 3 – – 4 –
Front Panel of VDR-301N
Interfaces and Ports of VDR-301N
VDR-301N
Quick Guide
RJ11 Cable
VDSL Splitter
The above steps introduce the simple installation and configura-
tions of the VDR-301N. For further configurations of different
operation modes, please refer to the user manual, which can be
downloaded from the website.
http://www.planet.com.tw/en/support/download.php?type1=32
0&model=48957&type=3
If you have further questions, please contact the local dealer or
distributor where you purchased this product.
Thank you for choosing PLANET VDR-301N. Before installing the
AP, please verify the contents inside the package box.
If there is any item missing or damaged, please
contact the seller immediately.
Step 1: Connect the Power Adapter to VDR-301N. Check
whether the PWR LED and LAN LED on the front panel
are on accordingly.
Step 2: Follow the figure below to connect the network
devices.
VDR-301N
Quick Installation Guide
802.11n Wireless VDSL2 Bridge Router
Steps: Set your computer to get an IP address from the
Wireless Router:
1. Click the “Start” button located at lower-left corner of the
screen.
2. Click “Control Panel”.
3. Double-click “Network and Sharing Center” icon.
4. Click “Change Adapter Settings”.
5. Double-click the “Local Area Connection” icon.
6. Select “Internet Protocol Version 4 (TCP/IPv4)” and
click the “Properties” button.
7. Select “Obtain an IP address automatically” and
“Obtain DNS server address automatically”, and then
click the “OK” button twice to save the configuration.
VDSL2 Router with PPPoE:
Follow the steps below to set up connection to PPPoE mode.
1. Log in the VDR-301N’s web-based configuration utility.
2. Click “Setup”.
3. Select “DSL WAN”.
4. Choose PTM, and then select the Channel Mode to
“PPPoE”.
5. Select the IP Protocol to “IPv4”.
6. Fill in User Name and Password which are provided by
ISP.
7. After setting it up, press “Add”.
If you need more information about WAN service, please refer
to the User’s Manual.
VDSL2 Router with Bridge:
Follow the steps below to set up connection to Bridge mode.
1. Log in the VDR-301N’s web-based configuration utility.
2. Click “Setup”.
3. Click “DSL WAN”.
4. Choose PTM, and then select the Channel Mode to
“Bridge”.
5. Select the IP Protocol to “IPv4”.
6. Press “Add”.
If you need more information about WAN service, please refer
to the User’s Manual.
Power Adapter
RJ45 Cable
Default IP Address: 192.168.1.1
Default User Name: admin
Default Password: admin
Default SSID: PLANET_XXXX
(“X” means the last 4 digits of the MAC address.)
Now, you can see the Web management UI of the VDR-301N.
2. Physical Introduction
4. Web Login
5. Broadband Connection for VDSL Further Information
3. Hardware Installation
Power Adapter
Power
LINE
PHONE
MODEM
Power
Adapter
Power
RJ11
RJ45
PC/Laptop
Splitter
Phone
Jack
Telephone
PHONE
MODEM
DSL
WAN
WLAN
Power
12V DC
WPS
Reset
LAN1~4
Power
DSL
WPS
WLAN
Internet
LAN1~4
PLANET Technology Corp.
11F., No. 96, Minquan Rd., Xindian Dist., New Taipei City 231, Taiwan
2011-AC0390-000
To Next Page
Need help?
General
