Planet WDAP-1750AC - LAN Port; Figure 5-6 Network Settings - Lan Port

User Manual of WDAP-1750AC
-31-
Object Description
Primary Address
DHCP users can select “From DHCP” to get primary DNS server’s IP
address from DHCP or “User-Defined” to manually enter a value.
For static IP users, the default value is blank.
Secondary
Address
DHCP users can select “From DHCP” to get secondary DNS server’s
IP address from DHCP or “User-Defined” to manually enter a value.
For static IP users, the default value is blank.
5.2.2 LAN Port
The “LAN Port” page allows you to configure the settings for your access point’s two wired LAN (Ethernet) ports.
Figure 5-6 Network Settings - LAN Port
The page includes the following fields:
Object Description
Wired LAN Port
Identifies LAN port 1 or 2.
Enable
Enable/disable specified LAN port.
Speed & Duplex
Select a speed and duplex type for specified LAN port, or use the
“Auto” value.
LAN ports can operate up to 1000Mbps and full-duplex enables
simultaneous data packets transfer/receive.
Flow Control
Enable/disable flow control.
Flow control can pause new session request until current data
processing is complete, in order to avoid device overloads under
heavy traffic.
802.3az
Enable/disable 802.3az. 802.3az is an Energy Efficient Ethernet
feature which disables unused interfaces to reduce power usage.