The first time you power on your headphones, the
pairing process begins.
If your phone supports Near Field Communication (NFC) go
to NFC pairing (Android).
1
Slide the power switch on. You hear "pairing" and the
LEDs flash red and blue.
2
Activate Bluetooth
®
on your phone and set it to search
for new devices.
• iPhone Settings > Bluetooth > On*
GET PAIRED
• Android Settings > Bluetooth: On > Scan for devices*
*Menus may vary by device.
3
Select “PLT BB PRO 2.”
If necessary, enter four zeros (0000) for the passcode
or accept the connection.
Once successfully paired, you hear “pairing
successful” and the LEDs stop flashing.
1
Better model only Ensure NFC is on and your phone’s
display is unlocked. (Phones may vary.)
2
Tap and hold the headphones to the phone’s NFC tag
location until NFC pairing completes. If necessary,
accept the connection.
NOTE The headphone’s NFC tag is located on the outside of
the left ear cup. (Phone tag locations vary.)
MEDIA CONTROLS
Power on/off
Slide the switch to power on or off.
Play/pause music
Tap the Play/pause button.
Track selection
Tap the Forward button
or Back button to
control the track selection.
Volume
Rotate the volume wheel forward (+) or backward
(–) to control the volume.
PHONE CONTROLS
Answer or end a call
Tap the Call button.
Call back last call
Double-tap the Call button .
Mute
During a conversation, press the Mic button . You
hear “mute on” or “mute off.” While the microphone is
muted, an alert repeats every 15 minutes.
Pair mode
Slide and hold the power button towards the
Bluetooth icon until the LEDs flash red and blue.
To Next Page
Need help?
General
