1 Plug one end of the power supply into the power supply jack on the back of the MDA220 and the
other end into a working power outlet.
2 Firmly press the handset lifter power cord into the handset lifter jack.
3 While wearing your headset, slide the handset lifter arm until the lifter base touches the side of the
phone.
4 Slide the lifter up to where it nearly touches the handset earpiece.
5 Press the call button on your headset to activate the lifter.
6 If you hear a dial tone the lifter is set correctly and needs no adjustment.
7 Remove the protective strips from the 3 mounting tapes on the underside of the lifter.
8 Gently place the lifter on the desk phone in the pre-determined position.
9 Press firmly to adhere.
Desk Phone Plus HL10
and Power Supply (sold
separately)
10
To Next Page
Loading...
