A. The PLOTMASTER 400™ consists of a sturdy MAIN
FRAME with various components and attachments
that may be added or removed.
Each PLOTMASTER 400™ comes with a 1-point and
3- point hitch. The 1-point hitch has a 2” coupler which
is designed to fit any 2” ball hitch. The 2” coupler can be
adjusted from 1 7/8’ to 2” by loosening or tightening the
nut on the bottom of the coupler
B. The 1-POINT HITCH is designed to hook up with many
types of pulling machines and vehicles. Examples are ATV’s,
Utility Vehicles, small tractors, large lawn-mowers, trucks,
jeeps and 6x6 vehicles. Notice that the 1-point hitch has four
holes for different tongue heights. You can adjust the height
of the 1-point hitch by raising or lowering the 1-point hitch
inside the 2 1/2” square upright receiver. Adjustment of the
1-point hitch allows the unit to be tilted forward for more
pressure on the harrow disc or angled back for more pressure
on the plow tips. There may be times when you may want to
have more pressure on the disc or more on the plows. Using
the bottom hole will apply more pressure to the disc whereas
the upper holes will supply more pressure to the plow
attachment.
(HINT: We have found that in hard soil keeping the
unit level as possible works best for most application.)
If you plan to use your PLOTMASTER™ with a truck or
cargo ATV, you may need to purchase and electrical
extension cord. This extra extension will allow you to run
your control box to the cab of your truck or cargo ATV.
Your may also choose to have an extension for your battery
hookups. We carry extra long extension cords for the
batteries as well.
If you would like to add either of the extension cords to your
unit, please call our office at 1-478-864-9108.
To Next Page
Loading...